Axminster Engineer Series 운영 매뉴얼 - 페이지 8

{카테고리_이름} Axminster Engineer Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster Engineer Series 20 페이지. Pillar drill
Axminster Engineer Series에 대해서도 마찬가지입니다: 원본 사용 설명서 (16 페이지), 원본 사용 설명서 (16 페이지), 원본 사용 설명서 (19 페이지), 원본 사용 설명서 (18 페이지)

페이지 인쇄

same as press the "+" button.

5. Press 'Stop" button (the red and oval button is "0"), spindle will stop running, if press

'Start' button now, spindle runs to the speed last setting automatically. When you

operate the mill machine encounter emergency you can press the "Emgency stop

switch" the machine will power off.

6. Press the "Tapping" button ( drawing is a screw tap, the position up the "+" button), the

light above the 'Tapping' button lights. This means now is the 'Tapping mode', 'Forward'

and 'Reverse' buttons are unavailable.

7. Tapping: the highest speed under 'Tapping mode' is 500rpm.

Press the button end of the handle the first is "forward" when

press again it change to "reverse". Notice it have three handle all

can control so it is very easy to do.

See the picture on the right position.

8. Fine feeding function: When lock the Lock small handwheel (A), then the control handle

(B) can not useable. Turn the fine feeding handwheel (C) the spindle will micro remove.

Notice:

After using should turn the power switch to position '0' and pull out the plug from

socket.