AccuMASTER 7434 사용자 설명서 - 페이지 2

{카테고리_이름} AccuMASTER 7434에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuMASTER 7434 2 페이지. Digital angle gauge
AccuMASTER 7434에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지)

페이지 인쇄

With the AccuMASTER 2-in-1 Digital

Level and Angle Gauge you can find true

level and precisely check angles on saw

blades, jointer fences, drill press and

band saw tables, bevels and many more

precision tools. The AccuMASTER is

also useful for welders, fabricators,

installers or anyone who needs to find

true level and precise angle settings.

• Accuracy: ±0.2°

• Large, bright StayGlow™ display

stays on as long as you're using it

• Magnetically attaches to blades,

tables and more

• Finds both true level and

relative angles

• Reversible display (reads

upside down)

• IP54 certified – dust and water

resistant

• INCLUDES: 2-year warranty, 2

long-life AAA batteries and a

protective pouch

The LCD Display

Correct

IGITAL

Operation

1. Remove plastic battery tab before

use. Two AAA batteries are included.

2. Press ON/OFF button to power the

device. The display backlight stays

on until the device is turned off.

Press and hold ON/OFF button to

turn off. The device will turn off

after 3 minutes of inactivity.

3. To measure an angle, turn on and

put the device on the surface

being measured.

4. Press MODE to switch between

degrees, %, mm/m or in/ft.

5. If a surface isn't level, but you want

it to be your level starting point, you

can manually set it to 0° by pressing

SET 0. The

SET 0 again to cancel the function.

6. If you need to move the device to

read the display, press the HOLD

button to freeze the measurement.

icon will display. Press HOLD

The

again to return to measuring mode.

HOLD – save measurement

MODE – shows degrees, %, IN/FT, mm/m

Indicates tilt direction

SET O – set current level to 0°

Battery life

NGLE

AUGE

Incorrect*

*If the angle gauge is

tipped back more

than 45 degrees, the

display will show Err.

icon will display. Press