AccuMASTER 7434 사용자 설명서

{카테고리_이름} AccuMASTER 7434에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuMASTER 7434 2 페이지. Digital angle gauge
AccuMASTER 7434에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지)

페이지 인쇄
AccuMASTER 7434 사용자 설명서
Visit
AccuMASTER.com
to see our entire
line of
AccuMASTER
precision
measuring tools.
Setting 0° Calibration
Note: The device is calibrated in the
factory for maximum accuracy.
User can re-calibrate if necessary.
1. Turn off the device and place it on
a flat, smooth surface.
2. While the device is still off,
press the ON/OFF and HOLD
buttons together until the display
reads "CAL".
3. Press the HOLD button again and
the display will now read "CAL1".
4. Without picking up the device,
rotate it 180° and press the HOLD
button again. The display will
now read "CAL2". The 0°
calibration is now complete.
180°
All manuals and user guides at all-guides.com
4840 Hytech Drive
Carson City
NV 89706 USA
1-775-885-4900
E-mail:
calculated.com
UG7434E-D
Inclination Icon
As shown in the drawings, the
inclination icon shows you in what
direction you need to move an object
to get to level. The direction is
measured relative to the right side of
the gauge.
If the short line is above the longer
line, the right side is high and needs to
be lowered. Note that the arrow points
down, the direction which the right side
of the gauge should be rotated.
If the short line is below the longer line,
the right side needs to be raised. Note
that the arrow points up, the direction
which the right side of the gauge
should be rotated.
One large line indicates level, 0.0° .
U
'
G
SER
S
UIDE
D
A
G
IGITAL
NGLE
AUGE
Model 7434 v1.1
SET 0