Axminster Craft 105243 원본 사용 설명서 - 페이지 10

{카테고리_이름} Axminster Craft 105243에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster Craft 105243 16 페이지.

Changing the Grinding Stone/Dressing the Stone

Step 4

Remove plate flange and carefully remove the stone.

Clean the interior stone guard, inspect the new stone for

cracks and damage to either the front face or the edges

before fitting. Carefully slide the stone on the shaft, replace

the plate flange, the nut and tighten against the rotation

of the stone. DO NOT OVERTIGHTEN.

Step 5

Re-fit the stone guard cover and secure using the nuts/washers

you removed earlier.

CONNECT THE GRINDER

TO THE MAINS SUPPLY.

Reconnect the grinder to the mains supply, give the grinder

a 'short burst' , by switching it on and off quickly. Check the

grinder is not subject to any undue vibration. If the grinder

does vibrate, switch off immediately and disconnect from

the main supply. Remove the guard cover and check

stone and plate flange is fitted correctly. Check again, if

the grinder is still vibrating the stone/s may need dressing.

Dress the new stone lightly to ensure a 'good face' and

good concentricity.

CONNECT THE GRINDER

TO THE MAINS SUPPLY.

Switch on the grinder, wait until it reaches full speed and

leave the machine running for at least one minute before

carrying out any work. Apply a work piece and check that

the spark guard is correctly positioned and that the tool

rest is securely fixed. Switch off and wait until the grinder

comes to a complete stop.

DISCONNECT THE GRINDER

FROM THE MAINS SUPPLY.

After a period of time uneven wear on the stones including,

crests dips or rounded edges will appear. They will need to

be dressed out using a suitable wheel dressing stick. See

our website and in our catalogue for details, see fig 03-04.

Fig 03-04

Code 410074

Wheel Dressing Stick for coarse carborundum

and dressing worn or unbalanced wheels.