AXMINSTER TOOLS WORKSHOP AW1502WSG 원본 사용 설명서 - 페이지 10

{카테고리_이름} AXMINSTER TOOLS WORKSHOP AW1502WSG에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AXMINSTER TOOLS WORKSHOP AW1502WSG 17 페이지.

CHANGING THE GRINDING STONE

Step 5-6

Remove plate flange and carefully remove the stone.

Clean the interior stone guard, inspect the new stone

for cracks and damage to either the front face or the

edges before fitting. Carefully slide the stone on the

shaft, replace the plate flange, the nut and tighten

against the rotation of the stone. DO NOT

OVERTIGHTEN.

Step 7

CONNECT THE GRINDER

TO THE MAINS SUPPLY.

Reconnect the grinder to the mains supply, give the

grinder a 'short burst', by switching it on and off

quickly. Check the grinder is not subject to any

undue vibration. If the grinder does vibrate, switch off

immediately and disconnect from the mains supply.

Remove the guard cover and check stone and plate

flange is fitted correctly. Check again, if the grinder

is still vibrating the stone/s may need dressing. Dress

the new stone lightly to ensure a 'good face' and good

concentricity.

Step 8-9-10