AccuMed ABP802 사용 설명서 - 페이지 13

{카테고리_이름} AccuMed ABP802에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuMed ABP802 16 페이지. Upper arm blood pressure monitor

TROUBLESHOOTING

If you have trouble in using the unit please check the following points first.
ERROR DISPLAY
Nothing is displayed
when you push the
POWER button or
battery icon flashes.
Can't normally
increase pressure
Inflate pressure is too
high
Shaking while
measuring
Battery icon on
The systolic pressure
value or diastolic
pressure value too
high
The systolic pressure
value or diastolic
pressure value too
low
ACCOMPANYING DOCUMENTS
A. Instructions for use
1.MODEL ABP802 needs special precautions regarding EMC and needs to be installed and
put into service according to the EMC information provided in the ACCOMPANYING
DOCUMENTS;
2. Portable and mobile RF communications equipment can affect MODEL ABP802.
B. Technical description
1. Warning that the use of accessories, transducers, and cables other than those specified
with the exception of transducers and cables sold by the manufacturer of the MODEL ABP802
as replacement parts for internal components, may result in increased EMISSIONS or
decreased IMMUNITY of the MODEL ABP802.
2. Warning that the MODEL ABP802 should not be used adjacent to or stacked with other
equipment
POSSIBLE CAUSE
No battery installation
Batteries are dead
The batteries are installed
correctly
Check your arm cuff for any
air leakage
Hand or body shaking while
measuring
Batteries have low power
The arm cuff was held lower
than your heart
The arm cuff was not attached
properly
You moved your body or
spoke while measuring
The arm cuff was held higher
than your heart
You moved your body or
spoke while measuring
HOW TO CORRECT
Insert batteries
Replace with new batteries
Insert battery in the correct polarities
Replace arm cuff with new one
Re-measure or send back to dealer to
re-calibrate pressure
Keeping static and correct gesture to
measure again
Replace batteries and measure again
Keep the correct position, remain still,
and measure again
11