Arc Euro Trade SC3 분해 및 재조립 매뉴얼 - 페이지 6

{카테고리_이름} Arc Euro Trade SC3에 대한 분해 및 재조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arc Euro Trade SC3 17 페이지.

42. Remove the leadscrew guard.

44. The head may now be lifted clear

of the bed.

48. Press out the spindle assembly.

51. Press or pull off bearing and remove bearing

cover from spindle. Note the bearing fit.

If the bearings are tight to remove, polish the

spindle journals. The front bearing can be a press fit on the shaft but the rear bearing needs

to be push fit to allow accurate preload adjustments to be made by the two C-nuts.

53. Fit bearing cover and press on

nose bearing.

43. Remove the 2 hex socket and 2 hex head screws securing the head to the lathe bed.

45. Remove the front bearing

cover screws.

49. Press out the rear bearing.

54. Press front and rear outer bearing races into the head.

46. Remove lock nuts, gear, belt pulley,

2 spacers and the key from the

spindle rear.

50. Spindle assembly removed.

52. Polish the spindle and test the fit by using

- 6 -

47. Remove the rear bearing

cover.

one of the old bearings (if not damaged).