Accurate Technology Digi Scale Model 10 사용자 설명서 - 페이지 10

{카테고리_이름} Accurate Technology Digi Scale Model 10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurate Technology Digi Scale Model 10 17 페이지.

3. Referring to the figure, note these two installation requirements:

a. For accurate measurements, the guide clip should be mounted perpendicular to

the direction of travel of the Encoder.

b. Over the full range of travel, the guide clip should exert some pressure on the

Encoder so the two move as a single unit.

Note: Failure to use guide clip could void the warranty.

4. Reinstall the Encoder if it has been removed from the scale. Take care when sliding

the Encoder onto the scale so the brass "fingers" inside the Encoder do not get

damaged. (A slight "wiggling" motion when installing the Encoder on the scale will

simplify the process.)

5. Slide the Encoder until it meets and engages with the guide clip. Check that the

guide clip exerts sufficient pressure on the Encoder, as seen in the figure below.

6. Place the cable in a secure position. Do not leave the cable where it could be

damaged or pulled from the Encoder. Plug the Encoder into the Readout.

Note:If any other mounting method is used, observe the following:

a. Do not drill through the green portion of the scale at any point over which the

Encoder will travel.

b. Do not mount the scale so the mounting hardware interferes with the movement

of the Encoder.

R e a d h e a d

Accurate Technology Digi Scale

M o d e l 2 0 S c a le

Guide Clip Pressure/Spacing (End View)

M o v in g P a rt

G u i d e C lip

R e a d h e a d

G u id e C lip

3 3 . 0 m m ( 1 . 3 " )

2 1 . 2 m m

( .8 3 " )

Page 10 of 17