Accurate Technology Digi Scale Model 10 Manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Accurate Technology Digi Scale Model 10. Accurate Technology Digi Scale Model 10 17.
3. Referring to the figure, note these two installation requirements:
a. For accurate measurements, the guide clip should be mounted perpendicular to
the direction of travel of the Encoder.
b. Over the full range of travel, the guide clip should exert some pressure on the
Encoder so the two move as a single unit.
Note: Failure to use guide clip could void the warranty.
4. Reinstall the Encoder if it has been removed from the scale. Take care when sliding
the Encoder onto the scale so the brass "fingers" inside the Encoder do not get
damaged. (A slight "wiggling" motion when installing the Encoder on the scale will
simplify the process.)
5. Slide the Encoder until it meets and engages with the guide clip. Check that the
guide clip exerts sufficient pressure on the Encoder, as seen in the figure below.
6. Place the cable in a secure position. Do not leave the cable where it could be
damaged or pulled from the Encoder. Plug the Encoder into the Readout.
Note:If any other mounting method is used, observe the following:
a. Do not drill through the green portion of the scale at any point over which the
Encoder will travel.
b. Do not mount the scale so the mounting hardware interferes with the movement
of the Encoder.
R e a d h e a d
Accurate Technology Digi Scale
M o d e l 2 0 S c a le
M o d e l 2 0 S c a le
Guide Clip Pressure/Spacing (End View)
M o v in g P a rt
G u i d e C lip
R e a d h e a d
G u id e C lip
3 3 . 0 m m ( 1 . 3 " )
2 1 . 2 m m
( .8 3 " )
Page 10 of 17