Arcam A25 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Arcam A25에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcam A25 13 페이지.

Power

The power switch on the rear panel switches the amplifier on or off. When you have finished making
connections, switch the amplifier on.
Press the volume encoder to turn on the amplifier from standby.
Press and hold the volume encoder to put the amplifier in standby.

Auto Standby

This amplifier is designed to enter standby automatically within 20 minutes with no audio playing and no user
interaction. This is to meet international power consumption regulations. This can be turned off in the menu. To use
the menu, see page 10.

Selecting Inputs

Audio inputs can be selected using either:
The INPUT selector on the front panel. Rotate the dial to the input and press to select.
Using the left
corresponds to the labelled input sockets.
The inputs are:
Phono (analog – turntable with moving magnet cartridge)
Analogue 1, Analogue 2 and Analogue 3
Digital 1, Digital 2, Digital 3 and USB-C (USB-C on A25 only)
Note: The digital inputs only support stereo (PCM) audio. Multichannel audio or encoded audio of any
type is not supported.

Phono Input

The Phono Input includes a pre-amplifier to work with a MM (moving magnet) cartridge on a turntable for playing
vinyl.
NEVER connect anything other than a turntable through this input. This can result in serious
damage to both your amplifier and speakers and will not be covered under warranty.

Service USB

The Service USB socket on this amplifier is only intended for software updates. It is not an audio input.

Headphones

The headphone socket (PHONES) accepts headphones fitted with a 3.5mm stereo jack. By default, the pre-amp
outputs and speakers are muted when the headphones are plugged in.
Note: the speakers and pre-amp outputs can be configured to remain active when headphones
are connected using the Headphone Override function in the setup menu.

Processor Mode

Processor mode will fix the volume for one input. It can be assigned to any analogue input (excluding Phono). This
allows the amplifier to be used in conjunction with a home cinema receiver in a combined home cinema and two
channel system. Set the volume to match other speakers connected to the source amplifier or AVR using the
Processor Volume setting.
9
ARCAM A5_A15_A25 OM EN
and right
curcor buttons on the remote control. In each case, the source name