ABB Contrac RSD 200-5,0 사용 설명서 - 페이지 10

{카테고리_이름} ABB Contrac RSD 200-5,0에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB Contrac RSD 200-5,0 18 페이지. Electrical linear actuators for continuous modulating control

페이지 인쇄

9.5 Mounting the actuator to the valve

- Completely retract the actuator thrust rod and put the actuator on the valve yoke.

- Make sure the valve stem is centrically aligned with the bore and at right angles to the actuator seat

(permissible parallel deviation < 0.1 mm referred to total stroke).

- Fasten the actuator to the yoke with screws of property class 8.8 (tensile strength 800 N|mm

strength 640 N/mm

- Use the handhweel to extend the thrust rod, link the rod with the valve stem via the clutch.

- Manually retract the thrust rod to check whether or not the external stop of the actuator is on the

housing flange before the valve cone gets in touch with the cover.

- If required, adjust with the clutch (only possible within certain limits!)

Fig. 7: Mounting RSD ... (example)

)

thrust rod hood

cover screw for

limit stop adjustment

thrust rod

mechanical

position indicator

servomotor

handwheel

handwheel release

fastening screws (8.8)

external limit stop

coupling

valve stem

valve yoke

valve

(r00158e1)

; yield