Axus ELEGANCY ELA-1400FC-D 사용자 설명서 - 페이지 15

{카테고리_이름} Axus ELEGANCY ELA-1400FC-D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axus ELEGANCY ELA-1400FC-D 19 페이지. Elegancy elj-1400 series

CHAPTER 5. HOT SWAP COMPONENTS

The BROWNIE ™ supports the hot -swappable disk cartridges, power supply

modules and cooling fan unit. The following sections describe how to use the hot

swap feature.

To hot swap a disk, perform the following steps ( Refer "Installing the disk" ).

Slide the latch to the position of unlock.

Open the cartridge handle by sliding the release button and wait for the drive to

spin down (The disk LED on the drive bay will turn from green to red indicate

the disk is powered down.).

Lift the handle to disengage the disk cartridge from the slot.

Gently pull the disk cartridge out of the slot.

Replace the HDD.

Holding the cartridge handle, insert the cartridge into the bay along the plastic

guides until the handle begins to close.

Push down the handle to secure the cartridge into the ELEGANCYsystem.

Slide the latch to the position of lock.

The drive is now replaced. Once the drive has powered on, it will be added to the

RAID configuration automatically.

Once the power supply has defective, the LED on front panel will turn from green to

Red and the power supply buzzer will sound.

To hot swap a power supply module perform the following steps.

1. Push the reset button to stop the audible alarm on the rear panel.

2. Unscrew the defective power module unit.

3. Pull the handle to disengage the module from the power supply base.

4. Slide the module out completely from the power supply base.

5. Insert the new power supply module.

NOTE: Use the handle to slide the module in to the base until it engages to the base.

6. The LED will turn bright green to indicate it has powered on.