Axus ELEGANCY ELA-1400FC-D Gebruikershandleiding - Pagina 15

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Axus ELEGANCY ELA-1400FC-D. Axus ELEGANCY ELA-1400FC-D 19 pagina's. Elegancy elj-1400 series

Pagina afdrukken

CHAPTER 5. HOT SWAP COMPONENTS

The BROWNIE ™ supports the hot -swappable disk cartridges, power supply
modules and cooling fan unit. The following sections describe how to use the hot
swap feature.

Hot Swapping the Disk Drive

To hot swap a disk, perform the following steps ( Refer "Installing the disk" ).
1.
Slide the latch to the position of unlock.
2.
Open the cartridge handle by sliding the release button and wait for the drive to
spin down (The disk LED on the drive bay will turn from green to red indicate
the disk is powered down.).
3.
Lift the handle to disengage the disk cartridge from the slot.
4.
Gently pull the disk cartridge out of the slot.
5.
Replace the HDD.
6.
Holding the cartridge handle, insert the cartridge into the bay along the plastic
guides until the handle begins to close.
7.
Push down the handle to secure the cartridge into the ELEGANCYsystem.
8.
Slide the latch to the position of lock.
The drive is now replaced. Once the drive has powered on, it will be added to the
RAID configuration automatically.

Hot Swapping the Power Supply

Once the power supply has defective, the LED on front panel will turn from green to
Red and the power supply buzzer will sound.
To hot swap a power supply module perform the following steps.
1. Push the reset button to stop the audible alarm on the rear panel.
2. Unscrew the defective power module unit.
3. Pull the handle to disengage the module from the power supply base.
4. Slide the module out completely from the power supply base.
5. Insert the new power supply module.
NOTE: Use the handle to slide the module in to the base until it engages to the base.
6. The LED will turn bright green to indicate it has powered on.
15