Arcam SOLO MINI 핸드북 - 페이지 11
{카테고리_이름} Arcam SOLO MINI에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcam SOLO MINI 18 페이지. Music system
Arcam SOLO MINI에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 핸드북 (20 페이지)
FM
An FM aerial is required to receive VHF radio signals.
In strong signal areas, the supplied FM wire aerial can
be used with reasonable results.
Connect the supplied aerial to the centre terminal of
the
coaxial connector input on the rear panel of the
FM
unit. Experiment with the position of the aerial to get
the best reception.
AM
An AM aerial is required to receive AM/medium wave
radio signals, so a simple loop aerial is supplied as an
accessory. Follow the assembly instructions in the
adjacent diagram.
Make sure that the aerial is positioned well away from
Solo Mini itself, TVs, computers and other sources of
RF 'noise'. Rotate the aerial to discover which position
gives the best reception.
In weak signal areas, or when Solo Mini is in use inside
a steel-framed building (such as an apartment building),
a wire between 3 and 5 metres long can be used to
strengthen reception. Mount this high up outside the
building (if possible) and connect one end of this wire
to the 'AM' part of AM aerial input, in addition to the
loop aerial supplied (do not disconnect the AM loop
aerial).
In weak signal areas, or for optimal FM radio reception,
a roof- or loft-mounted aerial is advised as this will give
superior reception.
In some areas, cable radio may be available or, in an
apartment building, a distributed aerial system may
be installed. In either of these cases you should have
sockets in your home marked
or
(do not use
FM
VHF
those marked
); these should be connected to the
TV
coaxial connector on the rear of Solo Mini.
Assembling the AM loop aerial
1.
Release the tie-wrap and unwind the
twisted lead. Fold the plastic stand
forward through the loop frame.
D A
B
V H
F / F
M
FM
2.
Push the tab into the open slot in the
base of the stand. Press until the tab
clicks home.
11
3.
Connect the lead wires to the AM socket
at the rear of Solo Mini (the wires are
not polarised). Rotate the aerial's stand
until you obtain the best reception.