Arcam SOLO MINI Podręcznik - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik dla Konwerter mediów Arcam SOLO MINI. Arcam SOLO MINI 18 stron. Music system
Również dla Arcam SOLO MINI: Broszura (2 strony), Podręcznik (20 strony)

Drukuj stronę

An FM aerial is required to receive VHF radio signals.

In strong signal areas, the supplied FM wire aerial can

be used with reasonable results.

Connect the supplied aerial to the centre terminal of

the

coaxial connector input on the rear panel of the

unit. Experiment with the position of the aerial to get

the best reception.

An AM aerial is required to receive AM/medium wave

radio signals, so a simple loop aerial is supplied as an

accessory. Follow the assembly instructions in the

adjacent diagram.

Make sure that the aerial is positioned well away from

Solo Mini itself, TVs, computers and other sources of

RF 'noise'. Rotate the aerial to discover which position

gives the best reception.

In weak signal areas, or when Solo Mini is in use inside

a steel-framed building (such as an apartment building),

a wire between 3 and 5 metres long can be used to

strengthen reception. Mount this high up outside the

building (if possible) and connect one end of this wire

to the 'AM' part of AM aerial input, in addition to the

loop aerial supplied (do not disconnect the AM loop

aerial).

In weak signal areas, or for optimal FM radio reception,

a roof- or loft-mounted aerial is advised as this will give

superior reception.

In some areas, cable radio may be available or, in an

apartment building, a distributed aerial system may

be installed. In either of these cases you should have

sockets in your home marked

(do not use

VHF

those marked

); these should be connected to the

coaxial connector on the rear of Solo Mini.

Assembling the AM loop aerial

Release the tie-wrap and unwind the

twisted lead. Fold the plastic stand

forward through the loop frame.

D A

V H

F / F

Push the tab into the open slot in the

base of the stand. Press until the tab

clicks home.

Connect the lead wires to the AM socket

at the rear of Solo Mini (the wires are

not polarised). Rotate the aerial's stand

until you obtain the best reception.