Arcam T32 매뉴얼 - 페이지 5
{카테고리_이름} Arcam T32에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcam T32 20 페이지.
Mains switch
This switch isolates the unit from
mains power. The unit can be
placed in low power standby using
the
button on the front
sTandby
panel or P on the remote control
Power inlet
Connect the correct
mains cable here.
�����������
Ensure the voltage selected matches
This socket can either be used in conjunction with the
RS232 port for the connection of an rDock, or as a
standard line level input (see page 13).
Remote in
This allows remote-control
signals to be received by the T32
if the remote sensor is covered or
otherwise 'invisible' to the remote
control (see page 4).
��������������
O
I
��������
��������
�������
�����
������
�����
�����
Voltage select
the local power supply.
Program switch
For use by your Arcam dealer
during installation of software
updates.
RS232 control
This is used for connecting an rDock or rLead for
iPod® control (see page 6), or for controlling the T32
from a remote computer.
Your Arcam dealer can provide a copy of the RS232
remote control protocol if required.
Aux input
DAB aerial input
This input can be used with the ribbon aerial
provided, or connected to an external aerial (of the
correct type) if required.
���
��
����������
�
�
�
�
���
�
�
������
��
Analogue audio outputs
Connect these to your amplifier's tuner (or other line-
level) input using suitable high quality interconnect
cables. Ensure that the left and right audio outputs
from the T32 are connected to the corresponding left
and right inputs on your amplifier.
The second set of sockets can be used to connect to
a second amplifier set up for multi-room use, or for
direct recording.
E-5
(if fitted)
Sirius input
This input is for a SiriusConnect™ Home Tuner
module. Sirius is a subscription radio service that is
available throughout North America.
������
��� �������
������
AM aerial input
Connect the two AM Loop aerial
leads – they are not polarised. In
addition, a 3m–5m external wire
can be fixed to
to improve
aM Loop
reception (see page 9).
FM aerial input
This input can be used with the ribbon aerial
provided, or connected to an external aerial (of the
correct type) if required. In Europe, a Belling-Lee
connector is used; in North America, an F-type
(screw) connector is used.