Circe Cycles Helios 사용자 설명서 - 페이지 4
{카테고리_이름} Circe Cycles Helios에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Circe Cycles Helios 12 페이지. Separable tandem
Circe Cycles Helios에 대해서도 마찬가지입니다: 조립 설명서 (8 페이지), 소유자 매뉴얼 (15 페이지)
페이지 인쇄
2.0 Transporting your tandem
Depending on the method of transport the Helios separable tandem can be packed in a number of ways. For full protection,
suitable for air travel, we recommend either the one or two case system. For partial protection , suitable for car, boat or train
travel, we recommend using two soft bags.
2.1 One case system using the Traveller case
The one case system allows the whole tandem to go into one case and, depending on configuration, will also take the
optional Traveller Trailer Kit.
Restrictions
- Mudguards need to be removed
- Only certain pannier racks will fit in the case, racks need to be removed for packing.
- Ursus Jumbo stand has to be removed (Pletscher twin leg stand can be left on)
- Some bar configurations may be problematic.
Necessary tools
- 4, 5 and 6 mm allen key
- Pedal spanner
- Long nose pliers
2.11 Disassembly
Step 2.
Remove the captain seatpost, release the brakes
(applies to V brakes only) and turn the bike upside
down. Remove the wheels and skewers (for hub gears
follow the dedicated manufacturers' instructions for
wheel removal). Install the chain keeper into R/H rear
dropout as shown to hold the drive chain in place.
Release all the zip ties so the the cables are no longer
attached to the frame, this can be done with the end
of your finger nail or a small flat screwdriver.
Step 1.
Prepare your tandem for packing by removing the
pedals and ensuring the drive chain is in the smallest
sprocket at the rear (for derailleur gear system) for
hub gears ensure it is in the lowest gear with the least
cable tension.
Page 3