Circe Cycles Helios 조립 설명서 - 페이지 4

{카테고리_이름} Circe Cycles Helios에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Circe Cycles Helios 8 페이지. Separable tandem
Circe Cycles Helios에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 소유자 매뉴얼 (15 페이지)

페이지 인쇄

• 15mm pedal spanner

• Di2 tool (STEPS Triplet) supplied

• Long nose pliers or chainlink pliers (Triplet)

INSTALLING STEERER EXTENDER

The steerer extender fits to the top of the fork and

locates on the 4-pointed star, the slot at the back

of the extender should align with the vertical slot on

the side of the top cap.

Ensure the steerer is fully pushed down before

tightening the Q/R.

Fit the handlebar to the stem using an Allen key

and tighten according to the torques settings in the

torque table Appendix A.

Extender

Top cap

CirceCycles.com

INSTALLING FRONT WHEEL

The front wheel is fitted using a thru axle, that is

pushed through from the left side of the bike (disc

brake side) and then tightened using a 6mm Allen

key. When installing the wheel make sure the disc

rotor is aligned between the pads, before pushing

the wheel into the fork ends.

NOTE – with hydraulic brakes, first remove the

orange pad spacer before installing the wheel.

INSTALLING FRONT MUDGUARD

The front mudguard attaches in three places; the

fork crown and hte bottom of each fork leg. You

will need a 6mm Allen key and 10mm spanner to

fasten the bolt at the fork crown and a pair of pliers

to help insert the stays into the plastic clips, though

this can be done by hand.

you have a front light or Hebie steering stabaliser

you will have to attach these at the fork crown with

the mudguard.