Circe Cycles Helios 조립 설명서 - 페이지 6

{카테고리_이름} Circe Cycles Helios에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Circe Cycles Helios 8 페이지. Separable tandem
Circe Cycles Helios에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 소유자 매뉴얼 (15 페이지)

페이지 인쇄

Install the triplet section on to the front part of

the bike , pushing it on until the crossbar coupling

meets with the coupling on the frame.

Note - Ensure the brake and gear cable (if

mechanical system) are on the correct side of the

frame before proceeding.

Tighten the coupling on the crossbar first, then

tighten the pinch bolts on the drainpipe (refer

to Appendix A for torque settings). This order is

important, as the coupling aligns the frame, and

the lower section needs to be free to rotate while

this happens.

You can now fit the rear triangle, following the

same procedure used for the front section. For

STEPS equipped bikes the cables will need to be

connected and threaded back into the Triplet

main tube before doing this.

1 - Di2 Alfine hub,

2 - STEPS speed

sensor

3 - lights (if fitted)

INSTALLING THE CHAINS

The middle stoker chain comes separated and

should be installed first; connection is via a quick

link.

CirceCycles.com

Depending on the configuration of your triplet, the

front timing chain comes pre-connected and can

be installed without separating. Once the chains

are in place the chains can be lifted on to the

tensioners.

INSTALLING THE CABLES

If you intend to switch between triplet and tandem

mode regularly then we suggest that you use the

Velcro straps provided to hold the cables in place

at the cable mounting points, otherwise the cables

can be held in place with zip ties.