Arcan CP500 조립 지침 매뉴얼 - 페이지 11

{카테고리_이름} Arcan CP500에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcan CP500 16 페이지. Shop press

WINCH KIT PARTS LIST

Winch - 1

Long Cable - 1

Short Cable- 1

WINCH INSTALLATION INSTRUCTIONS

Dark Gray- Long Cable

Light Gray- Short Cable

1. Move press bed into LOWEST position

so it is resting on top of pins 1 and 2.

CP500 Operation Manual

Cable Clamp - 1

1/2"-13 x 1-1/2"

Hex Head Bolts - 2

1/2" Nuts - 2

Washers - 2

Right side of press,

under pump assembly

2. Install pre-attached eye bolt on LONGER

cable to press bed handle located under

pump assembly. DO NOT FULLY TIGHTEN.

Center with side of press bed and make

sure there is enough room to lower or raise

both nuts on eye bolt for precise alignment.

WARNING

DO NOT FULLY TIGHTEN.

Right side of press

3. Thread the BARE end of the LONGER

of the two steel cables up and through

the pump bracket.