digico SD8 안전 지침, 설정 및 설치 매뉴얼 - 페이지 5

{카테고리_이름} digico SD8에 대한 안전 지침, 설정 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. digico SD8 13 페이지. Replacing and cleaning faders
digico SD8에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

digico SD8 안전 지침, 설정 및 설치 매뉴얼
Copyright © 2009 Digico (UK) Ltd
All rights reserved.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any
form by any means without the written permission of Digico UK Ltd. Information in this manual is subject to change without notice, and
does not represent a commitment on the part of the vendor. Digico UK Ltd shall not be liable for any loss or damage whatsoever arising
from the use of information or any error contained in this manual.
All repair and service of the SD8 product should be undertaken by Digico UK Ltd or its authorised agents. Digico UK Ltd cannot accept
any liability whatsoever for any loss or damage caused by service, maintenance, or repair by unauthorised personnel.
Digico (UK) Ltd
Unit 10
Silverglade Business Park
Leatherhead Road
Chessington, Surrey
KT9 2QL
England
Telephone:
+44 (0)1372 845600
Fax:
+44 (0)1372 845656
Email:
WWW:
http://www.digiconsoles.com
All trademarks are acknowledged as the property of their respective owners
Manual Issue: Issue A, October 2009
Electrical Safety Warning
Unlike most large conventional analogue consoles, the SD8 worksurface contains its own mains
power supply, and a variety of internal supply units and converters. These are fully insulated and
covered to meet the relevant electrical safety standards, but technicians working within the console
should be aware of the presence of mains voltage.
Note also the rack PSU if operated removed from the chassis has heatsinks exposed that are live to
mains voltage.
Also, SD8 contains a number of back-lit flat screen displays. The illumination system of these
displays uses line voltages of up to several KV, generated by high frequency DC - DC converters
located close to the displays. Touching or tampering with these circuits will put a technician at risk of
very damaging RF burns to the skin and/or high voltage electric shock.
Page 5