digico D-TuBe 매뉴얼 - 페이지 4

{카테고리_이름} digico D-TuBe에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. digico D-TuBe 6 페이지. 8 channel valve mic input card

D-TuBe

1.3 Hardware Installation

To install the D-TuBe follow these instructions:

NOTE: When inserting a card into a slot carefully insert the card's PCB into the

internal runners - do not insert the metal plate into the runners.

1) Switch the power off on the stage rack.

2) Remove the Mic Input card from slot 7 in the stage rack by unscrewing the two fixing

bolts and gently sliding the card out.

3) Remove the Line Output card from slot 8 in the stage rack and reinstall it in slot 9 by

removing the blank panel and inserting the card.

4) Install the D-TuBe card into the space left in slots 7 and 8.

5) Switch the rack power on and default the rack by pressing both of the DATA buttons at

the same time to enable paging mode. Then scroll up with the PAGE buttons until you see

the message "DEFAULT?" in the display. Press the DATA UP button and you will see the

message "SURE?" in the display. Press the DATA UP button again, the display will briefly

go blank and then return to the standard view.

6) The hardware installation is now complete - please read the next section for the soft-

ware configuration.

Remove Input Card 7

Move Output Card 1 From Slot 8 To Slot 9

Insert D-Tube in Slot 7 / 8

Hardware Installation Complete

1-4