Epson 10600 - Stylus Pro Color Inkjet Printer 빠른 참조 - 페이지 4
{카테고리_이름} Epson 10600 - Stylus Pro Color Inkjet Printer에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 10600 - Stylus Pro Color Inkjet Printer 10 페이지. Product brochure - efi fieryspark professional 2.0 rip
Epson 10600 - Stylus Pro Color Inkjet Printer에 대해서도 마찬가지입니다: 사양 시트 (8 페이지), 빠른 설치 매뉴얼 (34 페이지), 사양 (4 페이지)
페이지 인쇄
Checking and Cleaning the Print Head
Checking and Cleaning the Print Head
If you notice missing colors or horizontal banding (thin
light or dark lines) in your printouts, you may need to
clean the print head. First print a nozzle check pattern, as
described below. If dots are missing or out of place in the
pattern, then run a cleaning cycle.
1
Load a sheet of paper (or roll paper) in the printer.
2
Press the
SelecType
™
appears on the display.
PRINT MENU
3
Press the
button.
Item
appears on the display.
4
Press the
button. The nozzle check prints as
Enter
shown below:
If all the lines on the check pattern are complete, with
no gaps in the dot pattern, the print head doesn't
need cleaning. (You may need to use an eye loupe to
check the pattern.)
button repeatedly until
TEST
NOZZLE CHECK = PRINT
If dots are missing from the pattern, as shown below,
you need to run a cleaning cycle.
5
Make sure that all of the
printer's control panel are off. If an
flashing or on, you need to replace the corresponding
ink cartridge instead.
6
Press the
Cleaning
3 seconds. The
Pause
cleans its print head. The cleaning cycle takes about
a minute and does not use any paper.
To avoid damaging the printer, don't turn it off
until the cleaning cycle is finished and the
Pause light has stopped flashing.
7
When the
Pause
4 to run another nozzle check to make sure the print
head is clean.
4
lights on the
Ink Out
light is
Ink Out
button and hold it for at least
light flashes as the printer
light goes off, follow steps 1 through