Epson 1160 CFS 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Epson 1160 CFS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 1160 CFS 12 페이지.

7. Attach Ribbon Tube to Bracket

Move the cartridges to the left position, manually. Power is still off.

Insert tubing into the bracket so that the tube closest to you is in the front. This is

the yellow tube. Make sure the tubing is secure and all the way into the bracket. Use

some alcohol to lubricate the tubing and the bracket. Pull the tubing through the

bracket to take up the slack. You will have to make some adjustments so that the

tube is not to tight when the carts are in the left most position. As the cartridges

traverse from left to right, the tubing should not touch the bottom of the carriage.

8. Install the Switch Activator

These two pieces of rigid foam are the Switch Activators (see photo). Push them

down gently into the front of the cartridge holder, where the end of the clamp

previously went. They must be inserted deep to activate the switch. They are tight

enough to stay in place by themselves, no tape is necessary. If you push too hard, it

will make the lights will come back on again when the power is on. Just push hard

enough to activate the switch.

When you are done with the cartridges push them all the way to the right until

they stop. This is

power back on.

S a v e

M o n e y

MIS Associates Inc

http://www.inksupply.com

important

so that the belt does not jump when you turn the

a n d

I m p r o v e

2901 Auburn Rd

Fax: 248-289-6013

Y o u r

Auburn Hills, MI 48326

P r i n t i n g

800-445-8296