Axxess ASWC-1 지침 - 페이지 2

{카테고리_이름} Axxess ASWC-1에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess ASWC-1 5 페이지. Connections
Axxess ASWC-1에 대해서도 마찬가지입니다: 사용자 설명서 (6 페이지), 설치 지침 (4 페이지)

페이지 인쇄

If you are using an Eclipse or Kenwood radio

connector with the Brown and Brown/White wires into the male 3.5mm connector of the

ASWC-1 harness.

* For Kenwood radios or JVC's with the Blue yellow wire: Connect the

Kenwood/JVC SWC wire (normally Blue/Yellow) to the Brown wire of the ASWC-1.

Isolate and tape the Brown/White wire, it will not be used.

**Some of the newer Kenwood radios will auto-detect as a JVC. If this is the

case, you can use a 12k ohm resistor (included) in line between the Blue/Yellow and

brown wire of the female 3.5mm jack during programming. Or you can manually

set the radio type which is in ASWC-1 manual.

* For Eclipse radios: Connect the Eclipse SWC wires (Normally Brown and

Brown/Black) to the Brown and Brown/White wires of the ASWC-1. Brown goes to

Brown and Brown/White goes to Brown/Black.

* For Parrot Asteroid Smart or Tablet: Connect the ASWC-1 male 3.5mm

jack into the AX-SWC-PARROT (sold separately) female 3.5mm jack and plug the

4 pin end into the corresponding SWC plug on the radio.

* For XITE radios: Connect the steering wheel control SWC-2 wire to the

BROWN wire of the ASWC-1. Isolate and tape up the Brown/White wire, it will not be

used.

For all other radios

of the aftermarket radio, designated for an external SWC control interface. Please refer to

the aftermarket radios manual if you are in doubt where the 3.5mm connector of the

ASWC-1 goes.

Once all connections have been made, plug in the aftermarket radio if not done already.

* If this is the first time the ASWC-1 is being installed:

Aftermarket Radio Connection

, plug in the male 3.5mm connector of the ASWC-1 into the back

, plug the female 3.5mm