Axxess ASWC-1 지침 - 페이지 3

{카테고리_이름} Axxess ASWC-1에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess ASWC-1 5 페이지. Connections
Axxess ASWC-1에 대해서도 마찬가지입니다: 사용자 설명서 (6 페이지), 설치 지침 (4 페이지)

페이지 인쇄

1) Turn the ignition on; the led will start flashing rapidly which means the ASWC-1 is

looking for the vehicle and the radio. Go to step 3.

* If the ASWC-1 was installed before:

1) Turn the ignition on; the led will flash 1 time.

2) Hold down the reset button more then 2 seconds but less then 10 seconds, the led will

start flashing rapidly.

3) The ASWC-1 will automatically find the vehicle and radio.

4) After a couple of seconds the led should stop flashing and not light up for 2 seconds.

At this point, do not push any buttons.

5) After the 2 seconds there will be a series of 7 Green flashes, some short and some

long.

6) The led will pause for another 2 seconds then flash Red up to 15 times.

7) This is the end of the auto-detection stage. If the ASWC-1 detected the vehicle and the

radio successfully, the led will light up solid.

8) Make sure the steering wheel control buttons function correctly in the vehicle and

enjoy your radio.

So what if the led does not light up solid or the steering wheel controls do not function

properly? Check out troubleshooting section below.

Troubleshooting the Auto-Detect Mode

So you tried the auto-detect feature and at the end the led did not stay on solid, it started

flashing Red slowly, or the steering wheel controls did not function properly. That means

the ASWC-1 did not detect the vehicle or the proper radio. Follow these steps to

determine what happened:

First, some basic tips:

1) Verify that you have 12-volt accessory and a good chassis ground to the ASWC-1.