Axxess AX-FD1-SWC 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Axxess AX-FD1-SWC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-FD1-SWC 16 페이지. Ford data interface with swc 2007-up

페이지 인쇄

Note: If the next function on the list is not on the steering wheel, press the Volume-Up

button for (1) second until the L.E.D. comes on, and then release the Volume-Up button. This

will tell the AX-FD1-SWC that this function is not available and it will move on to the next

function.

5. To complete the remapping process, press and hold the Volume-Up button on the steering

wheel until the L.E.D. in the AX-FD1-SWC goes out.

Button assignment legend

1. Volume-Up

2. Volume-Down

3. Seek-Up/Next

4. Seek-Down/Prev

5. Source/Mode

6. Mute

7. Preset-Up

8. Preset-Down

9. Power

Not applicable if the vehicle is equipped with SYNC

Not applicable in this application

Note: Not all radios will have all of these commands. Please refer to the manual provided with the

radio, or contact the radio manufacturer for specific commands recognized by that particular radio.

STEERING WHEEL CONTROL SETTINGS

10. Band

11. Play/Enter

12. PTT (Push to Talk) *

13. On-Hook *

14. Off-Hook *

15. Fan-Up **

16. Fan-Down **

17. Temp-Up **

18. Temp-Down **

(CONT)

Dual assignment instructions (long button press)

The AX-FD1-SWC has the capability to assign (2) functions to a single button, except Volume-

Up and Volume-Down. Follow the steps below to program the button(s) to your liking.

Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and Preset-Down

for a long button press.

1. Turn on the ignition but do not start the vehicle.

2. Press and hold down the steering wheel control button that you want to assign a long press

function to for about (10) seconds, or until the L.E.D. flashes rapidly. At this point release the

button; the L.E.D. will then go solid.

3. Press and release the Volume-Up button the number of times corresponding to the new button

number selected. Refer to the Dual Assignment Legend. The L.E.D. will flash rapidly while the

Volume-Up button is being pressed, and then go back to a solid L.E.D. once released. Go to the

next step once the Volume-Up button has been pressed the desired number of times.

Caution: If more than (10) seconds elapses between pressing the Volume-Up button, this

procedure will abort, and the L.E.D. will go out.

4. To store the long press button in memory, press the button that you assigned a long press

button to (the button held down in Step 2). The L.E.D. will now go off indicating the new

information has been stored.

Note: These steps must be repeated for each button you would like to assign a dual

purpose feature to. To reset a button back to its default state, repeat Step 1, and then

press the Volume-Down button. The L.E.D. will go out, and the long press mapping for

that button will be erased.

Continued on the next page

REV. 7/19/2017 INSTAX-FD1-SWC