Axxess AX-FD1-SWC 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Axxess AX-FD1-SWC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-FD1-SWC 16 페이지. Ford data interface with swc 2007-up

페이지 인쇄

STEERING WHEEL CONTROL SETTINGS

Dual assignment legend

1. Not allowed

4. Seek-Down/

2. Not allowed

5. Mode/Source

3. Seek-Up/Next

6. ATT/Mute

* Not applicable in this application

Resetting the AX-FD1-SWC

1. With the radio on, turn the potentiometer:

Note: Before proceeding, remember the position the potentiometer is at.

Turn left

the LED will come on

Turn right

the LED will come on

Turn back left

the LED will come on

Turn right

the LED will come on

Turn back left

the LED will begin to flash rapidly

Turn back to the initial position

The rapid flash means the interface is starting its re-programming process.

2. The L.E.D. inside the interface will turn off for a couple seconds, then flash fast, then flash slowly (up to (18) times, indicating

which radio is connected to the interface), and then turn off. Pay close attention as to how many slow flashes there are. This

will help in troubleshooting, if need be. Refer to the L.E.D. feedback section for more information.

3. Within a few seconds the L.E.D. will turn on, and the radio will turn off.

4. Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the resetting and initialization

process was successful.

AxxessInterfaces.com

7. Preset-Up

10. Band

8. Preset-Down

11. Play/Enter

9. Power

12. PTT

hold until the LED goes out

(CONT)

13. On-Hook

16. Fan-Down *

14. Off-Hook

17. Temp-Up *

15. Fan-Up *

18. Temp-Down *

AX-FD1-SWC

I N S TA L L AT I O N I N S T R U C T I O N S

IMPORTANT

If you are having difficulties with the installation of this product,

please call our Tech Support line at 1-800-253-TECH. Before doing

so, look over the instructions a second time, and make sure the

installation was performed exactly as the instructions are stated.

Please have the vehicle apart and ready to perform troubleshooting

steps before calling.

NOWLEDGE IS

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certified technicians

REV. 7/19/17 INSTAX-FD1-SWC

OWER