Epson 220 매뉴얼 - 페이지 21

{카테고리_이름} Epson 220에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 220 29 페이지. Epson printer parts manual

페이지 인쇄

Removing the pull tractor

To remove the tractor from the pull position, follow

these steps:

1. Remove any paper loaded on the pull tractor.

2. Turn off the printer. Then remove the printer cover and lift

the paper guide up and off the printer.

3. Press the tractor lock tabs, tilt the tractor toward you, and

lift it off the printer. Store the tractor in a safe place, or

install it in the front push position.

4. Replace the paper tension unit by lowering onto the printer

mounting pegs. Then press down both ends of the unit

until it clicks into place.

5. Replace the paper guide and printer cover. Then close the

paper guide cover.

lock tab

Switching Between Printing on

Continuous Paper and Printing on

Single Sheets

With the push tractor installed, you can easily switch back and

forth between printing on continuous paper and printing on

single sheets without having to remove or reload paper.

Switching to printing on single sheets

To switch between printing on continuous paper to single sheets

with the front or rear push tractor, follow the steps below.

Note:

If continuous paper with labels is loaded in the printer, remove it

before switching to single-sheet printing. See "Removing continuous

paper with labels" on page 12.

If a tractor is in the pull position, remove any continuous paper from it

before switching to single-sheet printing. See "Removing paper from

the pull tractor" on page 20.

1. Remove any printed pages of continuous paper that remain

in the printer. Press the

them to the tear-off position, and tear them off.

Caution:

Tear off your printed document before you press the

Load/Eject button in the next step. Reverse feeding

several pages at a time may cause a paper jam.

Never use the knob to eject paper while the printer is

on; this may damage the printer or cause it to lose the

tear-off position.

2. Press the

Load/Eject

backward to the standby position. The paper is still attached

to the push tractor but is no longer in the paper path.

3. Load single sheets in the top or front paper guide.

Switching to printing on continuous paper

To switch between printing on single sheets to continuous

paper with the front or rear push tractor, follow these steps:

1. If a single sheet remains in the printer, press the

button to eject it.

Caution:

Never use the knob to eject paper while the printer is

turned on; this may damage the printer. The knob can be

used only when the printer is turned off.

2. Make sure that the tractor is installed in the push position

you want to use.

3. Load continuous paper onto the front or rear push tractor as

described earlier.

The printer loads the continuous paper automatically when

you begin printing.

2/99

EPSON LQ-2080

button to advance

Tear Off/Bin

button to feed the continuous paper

Load/Eject

EPSON LQ-2080

- 21