Epson 3880 - Stylus Pro Color Inkjet Printer 네트워크 매뉴얼 - 페이지 18

{카테고리_이름} Epson 3880 - Stylus Pro Color Inkjet Printer에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 3880 - Stylus Pro Color Inkjet Printer 38 페이지. Printer
Epson 3880 - Stylus Pro Color Inkjet Printer에 대해서도 마찬가지입니다: 브로셔 (3 페이지), 사양 (2 페이지), 네트워크 매뉴얼 (39 페이지), 브로셔 및 사양 (8 페이지), 여기에서 시작 (2 페이지), 여기에서 시작하기 매뉴얼 (6 페이지), 제한 보증 (12 페이지), 컬러 관리 매뉴얼 (47 페이지), 브로셔 및 사양 (8 페이지), 빠른 시작 매뉴얼 (2 페이지)

7. Press r, then press u or d to choose one of the following IP configuration

settings:

❏ Choose AUTO if your network uses a DHCP server to provide IP

addresses automatically. The printer's IP address will be obtained from

the DHCP server whenever the printer is reset or turned on, but may

change as IP addresses are reassigned over time.

❏ Choose PANEL if you would like to set the printer's IP settings

manually (recommended).

❏ Choose PING to set the printer's IP address using the arp command.

The IP address is set when the printer is turned off and then back on.

8. Press

. An asterisk ( ) appears next to the setting you selected.

9. Press l to go back, then do one of the following:

❏ If you selected AUTO as the IP address setting, press the

Cancel/Reset button to exit the printer menu. Then continue with step

14.

❏ If you selected PANEL as the IP address setting, continue with step 10.

❏ If you selected PING as the IP address setting, press the

Cancel/Reset button to exit the printer menu. Print a network status

sheet to determine the printer's MAC address (see "Printing a Network

Status Sheet" on page 19). Then use the arp command to set the IP

address from a computer on the same segment of your network as the

printer. Type the arp command on the command line using this format

(where X is the IP address you want to assign and Y is the MAC

address):

arp -s XXX.XXX.XXX.XXX YY-YY-YY-YY-YY-YY

After typing the command, continue with step 14.

10. Press d to highlight IP,SM,DG SETTING, then press r. The LCD displays

the IP address.

11. Press u or d to change each octet value, then press r to select the next

octet. When you have changed the value of the last octet, press r. The

LCD displays the subnet mask.

Setting Up Your System for Network Printing