Axxess AX-ADFD02 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Axxess AX-ADFD02에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-ADFD02 16 페이지. Ford data interface 2011-up

Attention! The AX-ADFD02 will work with both the AX-ADBOX1 and AX-ADBOX2 interfaces, but

programming will be different. Refer to the proper page for whichever interface is being used.

Also note, the programming instructions for the AX-ADBOX2 reflect gen. 2. If installing a gen. 1 AX-

ADBOX2, refer to the AX-ADBOX1 programming instructions. Gen. 2 interfaces can be distinguished

by a blue reset button between the (2) connectors.

AX-ADBOX2

Installing the AX-ADFD02

With the key in the off position:

• Connect the 16-pin harness with stripped leads, and the AX-ADFD02 harness, into the interface.

• If an ASWC-1 (sold separately) will be used, do not connect it until the AX-ADFD02 is

programmed and fully functional.

Attention! Do not connect the AX-ADFD02 harness to the wiring harness in the vehicle just yet.

Programming the AX-ADFD02

For the steps below, the L.E.D. located inside the interface can only be seen while active.

The interface does not need to be opened to see the L.E.D.

1. Start the vehicle.

2. Connect the AX-ADFD02 harness to the wiring harness in the vehicle. The L.E.D. will

initially be Green to indicate the interface is powered.

3. After a few seconds the L.E.D. will turn on solid Red while the interface automatically

programs to the vehicle. The radio will shut off at this point. This process should take 5 to

30 seconds.

INSTALLING & PROGRAMMING THE AX-ADFD02

4. After the interface is programmed, the L.E.D. will turn on solid Green, and the radio will

come back on, indicating programming was successful.

5. Test all functions of the installation for proper operation, before reassembling the dash.

6. If the interface fails to function, refer to "Troubleshooting", "Resetting the interface".

Troubleshooting

Resetting the interface

1. The Blue reset button is located inside the interface, between the two connectors. The

button is accessible outside the interface, no need to open the interface.

2. Press and hold the reset button for two seconds, then let go to reset the interface.

3. Refer to "Programming the AX-ADFD02 Interface" from this point.

Continue to Extra Features

REV. 6/27/2018 INSTAX-ADFD02