Axxess AX-LR904 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} Axxess AX-LR904에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-LR904 8 페이지. Land rover freelander 2 (with m.o.s.t. 25 amplifier) data interface with swc & factory display retention2006-2014
페이지 인쇄PROGRAMMING THE ASWC-1
INTERFACE
L.E.D. feedback
The (18) Red L.E.D. flashes represent what brand radio the ASWC-1 believes it is connected
to. Each flash represents a different radio manufacturer. For example, if you are installing
a JVC radio, the ASWC-1 will flash (5) times. Following is a legend that dictates which
manufacturer corresponds to which flash.
L.E.D. feedback legend
1 flash - Eclipse (Type 1) †
2 flashes - Kenwood ‡
3 flashes - Clarion (Type 1) †
4 flashes - Sony / Dual
5 flashes - JVC
6 flashes - Pioneer / Jensen
7 flashes - Alpine *
8 flashes - Visteon
9 flashes - Valor
* Note: If the ASWC-1 flashes Red (7) times, and you do not have an Alpine radio connected
to it, that means the ASWC-1 does not detect a radio connected it. Verify that the 3.5mm
jack is connected to the correct steering wheel jack/wire in the radio.
** Note: Part number AX-SWC-PARROT is required (sold separately). Also, the Parrot radio
must be updated to rev. 2.1.4 or higher through www.parrot.com.
† Note: If you have a Clarion radio and the steering wheel controls do not work, change the radio
type to the other Clarion radio type; same for Eclipse. The following section explains how to do this.
‡ Note: If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC
radio, change the radio type to a Kenwood. The following section explains how to do this.
4
(CONT.)
10 flashes - Clarion (Type 2) †
11 flashes - Metra OE
12 flashes - Eclipse (Type 2) †
13 flashes - LG
14 flashes - Parrot **
15 flashes - XITE
16 flashes - Philips
17 flashes - TBD
18 flashes - JBL
SCREEN OPERATION
Configuration Menu
Vehicle Settings
Interface Settings
Language
Version
< Back
Configuration Menu
• The buttons on the steering wheel will be used to
operate the configuration menu, which will be shown
on the aftermarket radio. To enable the menu, push and
hold the MODE button for 2 seconds. Use the Track Up
and Track Down buttons to navigate through the menu.
To select a menu option, push the MODE button once.
Continued on the next page