Axxess RFASWC 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Axxess RFASWC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess RFASWC 12 페이지. Wireless swc universal add-on
Axxess RFASWC에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지)

페이지 인쇄

5. The led will then flash up to 10 times.

6. This is the end of the auto detection stage. If the RFASWC detected

the radio successfully the led will light up solid red.

7. Make sure the steering wheel control buttons function correctly in the

vehicle and enjoy your radio.

So what if the led does not light up solid red? Check out troubleshooting

section below.

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on

solid red, it started flashing. That means the RFASWC did not detect the

radio. Follow these couple steps to determine what happened:

First some basic steps:

1. Verify that you have 12 volt accessory and a good ground to the

RFASWC.

2. Verify that the 3.5mm connector is connected to your radio securely

and in the correct location.

3. If using the female 3.5mm connector on an Eclipse or Kenwood radio,

verify that the radio's SWC wire is connected to the correct wire on

the RFASWC.