Epson AcuLaser C8600 빠른 참조 - 페이지 5
{카테고리_이름} Epson AcuLaser C8600에 대한 빠른 참조을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson AcuLaser C8600 23 페이지. Epson aculaser c8600: specifications
Epson AcuLaser C8600에 대해서도 마찬가지입니다: 설정 매뉴얼 (44 페이지), 사양 (1 페이지)
페이지 인쇄
Cover A Open
Cover A, the output path cover on the left
side of the printer, is open. Close the cover
and the error is automatically cleared.
Cover D Open
Cover D, the paper cassette cover on the
right side of the printer, is open. Close the
cover and the error is automatically cleared.
Cover E Open
Cover E, the cover on the right side of the
optional Large Capacity Paper Unit, is open.
Close the cover and the error is
automatically cleared.
Cover F Open
Cover F, the optional Duplex Unit's inverter
cover on the left side of the printer, is open.
Close the cover and the error is
automatically cleared.
Duplex Mem Overflow
There is not enough memory for duplex
printing. The printer prints only on the front
and ejects the paper. To clear this error,
follow the instructions below.
If Off is selected as the Auto Cont setting on
the control panel's Setup Menu, press the
Start/Stop button to print on the back of the
next sheet, or press the
to cancel the print job.
If On is selected as the Auto Cont setting on
the control panel's Setup Menu, printing
continues automatically after a certain
period of time.
Job Cancel button
EPSON AcuLaser C8600 Quick Reference
Format Error ROM A/Format Error Rom B
An unformatted ROM module has been
inserted. If the ROM module has been
formatted, but is still unreadable, format it
again. If the ROM is still unreadable after
reformatting, take the module to your dealer
for repair or replacement.
To clear this error, either press the Start/Stop
button or turn off the printer and remove the
ROM module.
Form Data Canceled
Unable to store form overlay data on the
printer's Hard Disk Drive. Either the drive is
full, or the maximum number of form
overlay files has been reached. Delete any
form overlay files you no longer need, then
try storing the new overlay again.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
Form Feed
The printer is ejecting paper due to a printing
error. This message appears when the
Start/Stop button has been held down for
more than 2 seconds in order to recover from
a printing error.
Front Cover Open
The front cover is open. Close the cover and
the error is automatically cleared.
Hard Disk Full
The printer has insufficient memory. Delete
the unnecessary data from the Hard Disk
Drive. To clear this error, select Clear
Warning from the control panel's Reset
Menu. See "How to access the control panel
menus" for instructions.
Status and Error Messages (2/8)