Epson AcuLaser CX11NF 사용자 설명서 - 페이지 13

{카테고리_이름} Epson AcuLaser CX11NF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson AcuLaser CX11NF 17 페이지. Multi-function colour laser printers
Epson AcuLaser CX11NF에 대해서도 마찬가지입니다: 기본 작전 구드 (26 페이지), 사양 (4 페이지), 설정 매뉴얼 (32 페이지), 여기에서 시작하기 매뉴얼 (8 페이지), 사양 (2 페이지), 보충 설명서 (6 페이지), 업데이트 (1 페이지), 제품 지원 게시판 (5 페이지), 사양 (4 페이지)

Replacing the Photoconductor

Handling Precautions

Always follow these precautions when replacing the

photoconductor:

❏ The photoconductor weighs 6.16 lb (2.8 kg). Be sure to

hold it firmly by the handle when carrying it.

❏ Avoid exposing the photoconductor to light any longer than

necessary.

❏ Be careful not to scratch the surface of the drum and belt.

Also, avoid touching the drum; oil from your skin may

permanently damage its surface and affect print quality.

❏ Do not store the photoconductor in an area subject to direct

sunlight, dust, salty air, or corrosive gases (such as

ammonia). Avoid locations subject to extreme or rapid

changes in temperature or humidity.

❏ Do not tilt the photoconductor.

Warning:

Keep the photoconductor out of the reach of children.

Do not dispose of a used photoconductor in fire, as it may explode

and cause injury. Dispose of it according to local regulations.

Removing and Replacing the

Photoconductor

1. Make sure the CX11N is turned on.

2. Remove any paper loaded in the ADF (CX11NF only).

3. Slowly flip back the scanner until it stops.

4. Close the output tray extension.

Epson AcuLaser CX11N/CX11NF

5. Lift up cover B.

6. Pull up the orange lever inside cover B.

7. Lift out the photoconductor using its handle.

8. Remove the new photoconductor from its package and pull

off the protective sheet.

8/05

Epson AcuLaser CX11N/CX11NF