Arch hth easiflo 1 75876 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Arch hth easiflo 1 75876에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arch hth easiflo 1 75876 11 페이지.

페이지 인쇄

EASIFLO 1 CHLORINATOR INSPECTION AND MAINTENANCE

Calcium Hypochlorite by the nature of its manufacture contains a small amount of calcium carbonate. Proper water

balance will minimize the buildup of calcium carbonate solids in the EASIFLO 1 Chlorinator, however, periodic

cleaning of chlorinator components is normal and recommended. The following is a list of the parts to be cleaned

and the proper procedures to do so.

TABLE OF CONTENTS

Suggested

Inspection

Section

Frequency

As Needed

Section A:

Section B

As Needed

SECTION A

Cleaning EASIFLO 1 Chlorinator with Hydrochloric Acid

Perform cleaning operation in a well ventilated area. Chlorine gas may evolve causing serious injury or

possible death. Use proper protective equipment per MSDS when handling chemicals. Use caution when

handling feeder parts and solution as they contain chlorine that can bleach clothing or cause injury

Inspection: The solids build-up and cleaning frequency required for the unit will depend on the amount of tablets used

and the pool water chemistry. Described below is the easiest way to remove solids and minor scale buildup using

dilute Hydrochloric Acid.

Maintenance Procedure Steps:

Note the inlet flow setting. Close the inlet and

outlet shutoff valves to the chlorinator.

Lift the Briquette Hopper away from the Discharge

Tank and pour the contents into a clean dry bucket.

Be sure to remove all pieces of briquettes. If

necessary, rinse any heavy solids buildup from the

hopper before proceeding.

Lift out dissolving cup, pour contents into a bucket

and rinse out solids.

Remove briquette grid and place in cup (provided

with system). Fill with 0.25 litres of water. Slowly

pour 0.25 litres of prepared 10 parts water to 1 part

acid into cup. Pour 5 litres of water and

acid solution into discharge tank.

agitation may be required to dissolve solids and

scale. Allow acid to dissolve solids and scale,

evident by the foaming action.

minutes, check for presence of scale on grid. If

Contents

Use of Hydrochloric Acid to remove solids and scale from the Easiflo 1

necessary, add additional acid solution to dissolve

any remaining scale or scrape with putty knife.

Replace the Dissolving Cup in Base.

Pour the contents from the cup with grid into

dissolving cup and allow 10 minutes for scale to

dissolve.

Put the hopper back on the base and the Briquette

grid back into the bottom of the hopper. Rinse the

Briquette grid thoroughly with water.

Pour Easiflo

Briquette Tank.

Open inlet and outlet shut off valves to the

chlorinator. Adjust inlet flow to desired setting.

litre of

Frequent

10. Dispose of chlorinated solution from step 2 either

into pool or skimmer.

NOTE:

After 10 to 20

allow briquette hopper to completely empty once per

week.

Chlorinator

Troubleshooting Guide

Briquettes from bucket back into

To increase the period between cleanings,