Epson AL-M200 Series 설정 매뉴얼 - 페이지 29

{카테고리_이름} Epson AL-M200 Series에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson AL-M200 Series 40 페이지. Wireless network setup guide
Epson AL-M200 Series에 대해서도 마찬가지입니다: 설정 매뉴얼 (2 페이지)

페이지 인쇄

1. Installing Print Drivers on Computers

4. Select WPS Setup, and then press the

5. Select Push Button Control, and then press the

6. Select Start, and then press the

7. Press and hold the WPS button on the access point.

8. Wait a few minutes until the printer restarts to establish the wireless network.

9. Print a System Settings page from the operator panel.

For more information, see the User's Guide.

10. Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.

Note:

When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.

WPS-PIN

Note:

❏ WPS-PIN is a method to authenticate and register devices required for wireless configuration, by

entering PIN code to a printer and computer. This setting, performed through access point, is

available only when the access points of your wireless router supports WPS.

❏ Before WPS-PIN starts, you will need to enter your PIN code at the web page of the wireless access

point. See the access point manual for the details.

1. On the operator panel, press the

2. Select Admin Menu, and then press the

3. Select Network, and then press the

4. Select WPS Setup, and then press the

5. Select PIN Code, and then press the

6. Take a note of PIN code displayed on the operator panel.

7. Select Start Configuration, and then press the

AL-M200 Series

button.

(Menu) button.

button.

Wireless Network Setup Guide