Creda PW E4ZC 사양 시트 - 페이지 2
{카테고리_이름} Creda PW E4ZC에 대한 사양 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Creda PW E4ZC 14 페이지. Creda towel rails and bathroom warming solutions specification sheet
Creda PW E4ZC에 대해서도 마찬가지입니다: 기술 사양 (5 페이지)
페이지 인쇄
Eco-Response
Storage radiant heaters
Conventional heater
1
2
With a conventional 'wet'
The building shell has
heating system, when
to then be warmed
heating goes off,
again before room
building shell cools.
feels comfortable.
Eco-Response
1
2
It is smarter to
The room temperature
can be raised quickly
maintain low level
and efficiently when
background heat.
needed.
Control options
4 zone pilot wire central controller
Allows 7 day programming of comfort/setback time
settings of multiple pilot wire linked heaters in up to
4 separate zones.
Ref: 75 770916
Matching TPRIII E
Electronic panel
heaters also available
for pilot wire linked
heating systems
(See page 12-13).
Advanced control
heating systems
3
This takes time and
energy - slow response.
3
Economical.
Responsive.
Intelligent.
+44 (0) 1733 456789
www.creda-heating.co.uk
Technical Specification
• Elements (Storage) - 650W incoloy sheathed, mineral
filled elements
• Element (Direct Acting) - cable-on-foil thin facia panel
• Thermostat (Input) - integral electronic charge limiter
Maximum core temperature 670
o
C/690
• Thermostat (Output) - integral electronic thermostat with child
lock facility
• Thermal Insulation - Carbowool 128kg/m
and calcium silicate
• Energy Retention Cells - high density bonded magnetite
• Protection (Storage) - automatic reset core limit thermostat and
manual over-temperature cut out
• Protection (Direct Acting) - automatic reset limit thermostat and
automatic reset over-temperature cut out
• Finish - white polyester and zinc coated steel with grey base
• Cable (Storage) - 1.6m 2.5mm
2
3 core
• Cable (Direct Acting) - 1.6m 0.75mm
2
• Supply - 230/240V AC single phase
Dimensions
Model
Height A
Width B
Depth C
ER300
712mm
600mm
130mm+10mm
ER400
712mm
830mm
130mm+10mm
ER500
712mm
1060mm
130mm+10mm
Minimum clearance required
• 75mm either side of heater
• 150mm in front of the heater
• 250mm directly above the heater
o
C at full charge
2
, Microtherm G
2 core
Feet Position D
295mm
523mm
751mm
9