Creda PW E4ZC Arkusz specyfikacji - Strona 2
Przeglądaj online lub pobierz pdf Arkusz specyfikacji dla Produkt hydrauliczny Creda PW E4ZC. Creda PW E4ZC 14 stron. Creda towel rails and bathroom warming solutions specification sheet
Również dla Creda PW E4ZC: Specyfikacja techniczna (5 strony)
Drukuj stronę
Eco-Response
Storage radiant heaters
Conventional heater
1
2
With a conventional 'wet'
The building shell has
heating system, when
to then be warmed
heating goes off,
again before room
building shell cools.
feels comfortable.
Eco-Response
1
2
It is smarter to
The room temperature
can be raised quickly
maintain low level
and efficiently when
background heat.
needed.
Control options
4 zone pilot wire central controller
Allows 7 day programming of comfort/setback time
settings of multiple pilot wire linked heaters in up to
4 separate zones.
Ref: 75 770916
Matching TPRIII E
Electronic panel
heaters also available
for pilot wire linked
heating systems
(See page 12-13).
Advanced control
heating systems
3
This takes time and
energy - slow response.
3
Economical.
Responsive.
Intelligent.
+44 (0) 1733 456789
www.creda-heating.co.uk
Technical Specification
• Elements (Storage) - 650W incoloy sheathed, mineral
filled elements
• Element (Direct Acting) - cable-on-foil thin facia panel
• Thermostat (Input) - integral electronic charge limiter
Maximum core temperature 670
o
C/690
• Thermostat (Output) - integral electronic thermostat with child
lock facility
• Thermal Insulation - Carbowool 128kg/m
and calcium silicate
• Energy Retention Cells - high density bonded magnetite
• Protection (Storage) - automatic reset core limit thermostat and
manual over-temperature cut out
• Protection (Direct Acting) - automatic reset limit thermostat and
automatic reset over-temperature cut out
• Finish - white polyester and zinc coated steel with grey base
• Cable (Storage) - 1.6m 2.5mm
2
3 core
• Cable (Direct Acting) - 1.6m 0.75mm
2
• Supply - 230/240V AC single phase
Dimensions
Model
Height A
Width B
Depth C
ER300
712mm
600mm
130mm+10mm
ER400
712mm
830mm
130mm+10mm
ER500
712mm
1060mm
130mm+10mm
Minimum clearance required
• 75mm either side of heater
• 150mm in front of the heater
• 250mm directly above the heater
o
C at full charge
2
, Microtherm G
2 core
Feet Position D
295mm
523mm
751mm
9