Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 사용자 설명서 - 페이지 30
{카테고리_이름} Epson C11C640001 - LX 300+II B/W Dot-matrix Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 50 페이지. Epson lx-300: user guide
Epson C11C640001 - LX 300+II B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 매뉴얼 (17 페이지)
페이지 인쇄
3.
The numbers next to the lever indicate the thickness setting. Use the
table below to select the appropriate paper thickness.
Paper type
Standard paper (single sheets or continuous)
Multipart forms
Labels
Envelopes
4.
Close the printer cover.
5.
Turn on the printer.
Multipart forms
You can use continuous or single-sheet carbonless multipart forms of up
to five parts (one original plus four copies). Follow these guidelines:
❏
Set the paper thickness lever to the correct position for your forms.
See page 29.
❏
Use continuous multipart forms that are joined only by spot gluing
or side-crimping. Never load continuous multipart forms joined by
metal staples, tape, or continuous gluing.
❏
Use single-sheet multipart forms that are line-glued only at the top.
Insert the forms glued-edge-first into the printer.
❏
Make sure that multipart forms are not wrinkled.
❏
If you need to adjust the loading position, use your application
software or change the loading position as described under
"Adjusting the top-of-form position" on page 23.
❏
When you use side-crimped continuous multipart forms, the copies
may not align with the original. If this happens, raise the paper
guide.
For multipart forms, you should not print any closer than 0.5 inch
(13 mm) from either side of the paper.
30
Paper Handling
2-sheet
3-sheet
4-sheet
5-sheet
Lever position
0
0
1
2
3
1
2 or 4