Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 매뉴얼 - 페이지 5
{카테고리_이름} Epson C11C640001 - LX 300+II B/W Dot-matrix Printer에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 17 페이지. Epson lx-300: user guide
Epson C11C640001 - LX 300+II B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 사용자 설명서 (50 페이지)
페이지 인쇄
Roll paper
A
Printable
area
A The minimum top margin is 0.17 inch (4.2 mm).
B The minimum left and right margins are 0.12 inch (3 mm).
The maximum printable width is 8 inches (203.2 mm).
Control Panel Buttons and Lights
1 Tear Off (Font) lights
Flash when continuous paper is in the tear-off position;
otherwise, the lights indicate the selected font.
2 Tear Off (Font) button
❏
Advances continuous paper to the tear-off position.
❏
Feeds continuous paper backward from the tear-off position
to the top-of-form position.
❏
In Micro Adjust mode, selects one of the six built-in fonts.
3 LF/FF button
❏
Feeds paper line by line when pressed and released.
❏
Ejects a single sheet or advances continuous paper to the
next top-of-form position when held down.
❏
In Micro Adjust mode, adjusts the top-of-form and tear-off
position.
B
7/06
4 Load/Eject button
❏
Loads a single sheet of paper.
❏
Ejects a single sheet of paper.
❏
Loads continuous paper from the standby position.
❏
Feeds continuous paper backward to the standby position.
❏
In Micro Adjust mode, adjusts the top-of-form and tear-off
positions.
5 Pause button
Stops printing temporarily, and resumes printing when pressed
again. When held down for three seconds, turns on Micro
Adjust mode. To turn it off, press it again.
6 Paper Out light
❏
On when no paper is loaded in the selected paper source or
when paper is not loaded correctly.
❏
Flashes when paper has not been fully ejected or if paper is
jammed in the printer.
7 Pause light
❏
On when the printer is paused.
❏
Flashes when the printer is in Micro Adjust mode.
❏
Flashes when the print head has overheated.
Selecting a Built-in Font
It is best to use your application program to select the font you
want to use in a document. However, you may sometimes need
to select one of the printer's six built-in fonts using the buttons
on the control panel, as described below. (The settings you
make in application programs usually override settings you
make from the printer's control panel.)
❏
❏
Draft
Draft Condensed
❏
❏
Roman
Roman Condensed
❏
❏
Sans Serif
Sans Serif Condensed
Epson LX-300+II
Epson LX-300+II
5
-