Digiever DIGIARRAY DA-4000E 빠른 설치 매뉴얼 - 페이지 6

{카테고리_이름} Digiever DIGIARRAY DA-4000E에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digiever DIGIARRAY DA-4000E 9 페이지.

 Change the RAID Type of DIGIARRAY

Please follow below steps to modify the RAID type of DIGIARRAY that has

been added to the NVR.

Remove DIGIARRAY from NVR



Remove the volume of DIGIARRAY from NVR Storage Volume Pool.



Unplug the eSATA cable from NVR.



Power off the DIGIARRAY by pressing its power button until the there

is a "beep" sound.

Clear RAID Type



Adjust DIGIARRAY's RAID type to "Clear RAID" on

the rear panel of DIGIARRAY.



Simultaneously press "reset button" and "power button" until there

is a beep sound. When DIGIARRAY powers on with a beep sound,

the RAID configuration is done.



Press the power button to power off DIGIARRAY

Change RAID Type



Adjust dip switch to configure RAID type.



Simultaneously press "reset button" and

"power button" until there is a beep sound.

When DIGIARRAY powers on with a beep

sound, the RAID configuration is done.



DIGIARRAY now is ready to connect to NVR.

Note: Before change DIGIARRAY's RAID type, please make sure

1. eSATA cable is unplugged to DIGIEVER NVR

2. DIGIARRAY has been removed from NVR's storage volume pool.