Aydin Displays VFP19R2-000-607 사용자 설명서 - 페이지 7

{카테고리_이름} Aydin Displays VFP19R2-000-607에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aydin Displays VFP19R2-000-607 14 페이지. Rugged vfp19-inch flat panel display

페이지 인쇄

DISPLAY CONNECTIONS AND ADJUSTMENTS:

If you have any problems connecting, setting up, or operating the display, please refer to the

Troubleshooting section of this guide.

DVI-D VIDEO Connector:

This input is used for Digital Video input, connect one end of the supplied DVI-D video cable to the

DVI-D connector on the rear of the display and the other end to a DVI-D connector on the video source.

HD15 VIDEO Connector:

This input is used for VGA Analog Video input, connect one end of the supplied VGA video cable to

the HD15 connector on the rear of the display and the other end to a HD15 connector on the video

source.

Plug the power cord into the rear of the display and then plug the cord into an AC power source. The

RED LED indicator will light. Turn on the display by pressing the ON/OFF button on the front panel.

The Green ON LED will light. If the RED (NO SYNC) LED is lit, refer to the Troubleshooting section.

CONTROLS:

Hot Buttons:

The following HOT Buttons are enabled when the OSD is NOT selected:

MUTE

UP, DOWN

AUTO ADJ

VIDEO

On-Screen-Menu (OSM) Controls:

The OSM controls on the front of the monitor function as follows:

To access OSM menu, press the OSD/ENTER Button.

To change the video input signal source, press the VIDEO button when OSM is NOT selected.

Control

MUTE/EXIT

OSD/ENTER

UP, DOWN

VIDEO

RESET

Note: When "RESET" is pressed, a warning will appear allowing you to cancel the reset function by pressing the EXIT button.

Document No. 150-VFP9-104 Rev. (A)

- Enables or disables the audio.

- Adjusts the audio volume

- Adjusts the image position, Horz. size, Vert. Size, and Fine settings.

- Sequentially search through all the video inputs until a video signal is detected.

Main Menu

Exits the OSM menu.

Enables the OSD Menu

Moves the highlighted area up/down

to select desired sub-menus.

N/A

Resets all controls to

Factory-default values.

Sub-Menu

Exits to the OSM main menu

Selects the adjustment bar or

Value selections.

Moves the highlighted area up

or down to select the desired

adjustment function.

N/A

Value/ADJ BAR

Exits to Sub-menu

N/A

Moves the bar left/right to

increase or decrease the

selected adjustment, or

select different values.

N/A