Architectural Control Systems 1560 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Architectural Control Systems 1560에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Architectural Control Systems 1560 6 페이지. Electric trim control, corbin 955 and yale 626f heavy duty trim

페이지 인쇄

TRIM CONTROL MOUNTING INSTRUCTIONS



PULL WIRE THROUGH 7/16" DIA. ACCESS HOLE FOR USE WITH OPTIONAL CONNECTOR AND

CABLE ASSEMBLY OR CONNECT WIRES WITH PROPER CRIMPS OR WIRE NUTS TO DOOR CABLE

INSIDE OF WIRE RACEWAY.

(NOTE: MAKE SURE WIRES DO NOT INTERFERE WITH MOVEMENT OF MECHANICAL LINKAGE)



MOUNT TRIM SECURELY WITH (2) SCREWS AND FINISHING WASHERS IN HOLES "B" OF FIGURE 1

NOTE: FOR SEVERE OUTDOOR ENVIRONMENTAL CONDITIONS IT IS RECOMMENDED THAT TRIM

ESCUTCHEON BE SEALED WITH THIN BEAD OF SILICONE SEALENT AROUND EDGE OF HOUSING

PRIOR TO MOUNTING.



WITH TRIM IN THE UNLOCKED POSITION CUT TAILPIECE TO 5/16" AS SHOWN ABOVE IN FIGURE 2.

REMOVE ALL SHARP EDGES AND BURRS FROM END OF TAILPIECE AFTER CUTTING.

NOTE: FOR 1560 (FAIL SAFE) DEVICES TAILPIECE IS IN UNLOCKED POSITION WHEN NO POWER

IS APPLIED. AND FOR 1570 (FAIL SECURE) DEVICES POWER MUST BE APPLIED TO DEVICE TO

POSITION TAILPIECE IN UNLOCKED POSITION PRIOR TO CUTTING.

NOTE: IF OPTIONAL CONNECTOR AND 4' FT. CABLE ASSEMBLY IS USED FOLLOW CABLE ASSEMBLY

WIRING INSTUCTIONS NEXT.



MOUNT DEVICE SO THAT TRIM TAILPIECE IS INSERTED INTO DEVICE CAM SLOT IN HORIZONTAL

POSITION AS SHOWN ABOVE IN FIGURE 1.



CONTINUE MOUNTING DEVICE ACCORDING TO MANUFACTURERS INSTRUCTIONS.

NOTE: IF RACEWAY IS USED FOR WIRE TRANSFER PROCEED TO POWER TRANSFER HOOKUP.

Rev. 11/2017

II-E1500-08