Architectural Control Systems 1560 Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Замки Architectural Control Systems 1560. Architectural Control Systems 1560 6 страниц. Electric trim control, corbin 955 and yale 626f heavy duty trim
Печатать страницуTRIM CONTROL MOUNTING INSTRUCTIONS
PULL WIRE THROUGH 7/16" DIA. ACCESS HOLE FOR USE WITH OPTIONAL CONNECTOR AND
CABLE ASSEMBLY OR CONNECT WIRES WITH PROPER CRIMPS OR WIRE NUTS TO DOOR CABLE
INSIDE OF WIRE RACEWAY.
(NOTE: MAKE SURE WIRES DO NOT INTERFERE WITH MOVEMENT OF MECHANICAL LINKAGE)
MOUNT TRIM SECURELY WITH (2) SCREWS AND FINISHING WASHERS IN HOLES "B" OF FIGURE 1
NOTE: FOR SEVERE OUTDOOR ENVIRONMENTAL CONDITIONS IT IS RECOMMENDED THAT TRIM
ESCUTCHEON BE SEALED WITH THIN BEAD OF SILICONE SEALENT AROUND EDGE OF HOUSING
PRIOR TO MOUNTING.
WITH TRIM IN THE UNLOCKED POSITION CUT TAILPIECE TO 5/16" AS SHOWN ABOVE IN FIGURE 2.
REMOVE ALL SHARP EDGES AND BURRS FROM END OF TAILPIECE AFTER CUTTING.
NOTE: FOR 1560 (FAIL SAFE) DEVICES TAILPIECE IS IN UNLOCKED POSITION WHEN NO POWER
IS APPLIED. AND FOR 1570 (FAIL SECURE) DEVICES POWER MUST BE APPLIED TO DEVICE TO
POSITION TAILPIECE IN UNLOCKED POSITION PRIOR TO CUTTING.
NOTE: IF OPTIONAL CONNECTOR AND 4' FT. CABLE ASSEMBLY IS USED FOLLOW CABLE ASSEMBLY
WIRING INSTUCTIONS NEXT.
MOUNT DEVICE SO THAT TRIM TAILPIECE IS INSERTED INTO DEVICE CAM SLOT IN HORIZONTAL
POSITION AS SHOWN ABOVE IN FIGURE 1.
CONTINUE MOUNTING DEVICE ACCORDING TO MANUFACTURERS INSTRUCTIONS.
NOTE: IF RACEWAY IS USED FOR WIRE TRANSFER PROCEED TO POWER TRANSFER HOOKUP.
Rev. 11/2017
II-E1500-08