ABB Safeball JSTD1-E 원본 사용 설명서 - 페이지 11

{카테고리_이름} ABB Safeball JSTD1-E에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB Safeball JSTD1-E 15 페이지. One/two hand enabling device

Operation

To activate a one hand device, both buttons on the Safeball must be pressed. Unlike a two-hand device, there is no

time requirement for activation of the two buttons. Instead, the safety distance is longer. Refer to Installation

precautions above for further details. The safety monitor must send a "stop" signal as soon as one or more

pushbuttons have been released, and check that both pushbuttons have been released before a new start is

possible.

To activate a two-hand device, the two individual one-hand devices must be activated within 0.5 seconds of each

other. This must be set up in the safety monitor by the safety application programmer. The safety monitor must also

send a "stop" signal as soon as one or more pushbuttons have been released, and check that all pushbuttons have

been released before a new start is possible.

A two-hand control system does not give any protection against parts or liquids which can be thrown out of a

machine. If it is required to protect other persons in the same risk area, either each person at risk should be

equipped with a further two-hand control system (suitably interlocked), or complementary protection should be

provided, e.g. a light curtain.

2TLC172182M0201, rev. F

www.abb.com/jokabsafety

2015-12-04