ABB TZIDC 빠른 시작

{카테고리_이름} ABB TZIDC에 대한 빠른 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB TZIDC 3 페이지. Digital positioner
ABB TZIDC에 대해서도 마찬가지입니다: 빠른 시작 (2 페이지), 사용 설명서 (10 페이지), 서비스 지침 (4 페이지), 시운전 지침 (2 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

TZID-C

Valve Positioner

Brief Operating Instructions for TZID-C With Software Rev. 1.1 and Lower

Commissioning

1. Turn on the air supply to the positioner.

2. Apply the 4...20 mA analog input signal to the positioner.

3. Check for proper mounting: refer to instruction manual if needed.

• Open front dust cover from positioner to access the local control keys.

• Press and hold MODE.

• Additionally briefly press

• Release MODE.

• Press

to move the actuator to its mechanical limit stops in both directions, and note the values.

The angle of rotation on the display is indicated in degrees. Recommended positions of limit stops:

> -28° and < +28° for linear actuators

> -57° and < +57° for rotary actuators

• Adjust the mounting position of the positioner in relation to the actuator if required.

Configuration

4. Switch to the configuration level:

• Press and hold

• Additionally briefly press ENTER.

• Wait until the countdown from 3 to 0 is completed.

• Release

The device will automatically go to program level "P1.0"

5. Select the actuator type "ROTARY" or "LINEAR" using

Note: This Step must be done prior to Autoadjust (Step 6)

until mode 1.3 MAN_SENS is displayed.

simultaneously.

QUICK-START

PN25087