ABB TZIDC Snel aan de slag

Blader online of download pdf Snel aan de slag voor {categorie_naam} ABB TZIDC. ABB TZIDC 3 pagina's. Digital positioner
Ook voor ABB TZIDC: Snel aan de slag (2 pagina's), Gebruiksaanwijzing (10 pagina's), Service Instructie (4 pagina's), Inbedrijfstellingsinstructies (2 pagina's), Handmatig (8 pagina's)

TZID-C

Valve Positioner

Brief Operating Instructions for TZID-C With Software Rev. 1.1 and Lower

Commissioning

1. Turn on the air supply to the positioner.

2. Apply the 4...20 mA analog input signal to the positioner.

3. Check for proper mounting: refer to instruction manual if needed.

• Open front dust cover from positioner to access the local control keys.

• Press and hold MODE.

• Additionally briefly press

• Release MODE.

• Press

to move the actuator to its mechanical limit stops in both directions, and note the values.

The angle of rotation on the display is indicated in degrees. Recommended positions of limit stops:

> -28° and < +28° for linear actuators

> -57° and < +57° for rotary actuators

• Adjust the mounting position of the positioner in relation to the actuator if required.

Configuration

4. Switch to the configuration level:

• Press and hold

• Additionally briefly press ENTER.

• Wait until the countdown from 3 to 0 is completed.

• Release

The device will automatically go to program level "P1.0"

5. Select the actuator type "ROTARY" or "LINEAR" using

Note: This Step must be done prior to Autoadjust (Step 6)

until mode 1.3 MAN_SENS is displayed.

simultaneously.

QUICK-START

PN25087