Digikeijs DR5033 사용 설명서 - 페이지 5

{카테고리_이름} Digikeijs DR5033에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digikeijs DR5033 18 페이지. 3-ampere, h-bridge dcc booster
Digikeijs DR5033에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 사용 설명서 (18 페이지)

페이지 인쇄

DR5033 DIGIBOOST

2.3 Hardware Overview

1 CDE Booster connec2on

(Please check whether the CDE connec2on of your control panel com-

plies with the requirements speciﬁed by Lenz®).

2 LocoNet® B Connector 1

3 LocoNet® B Connector 2

4 Tack Sniﬀer Input

By connec2ng the Track Sniﬀer input to the track output of the central unit, the track

signal is recognized even if none of the other input op2ons are available.

(CDE Booster connec2on, LocoNet® B, Roco® B Bus) can be used on the DR5033.

5 Roco® Booster Bus Connector 1

6 Roco® Booster Bus Connector 2

power supply

DC 15-19V 3,5A

8 Track Output

9 Booster Status LED

Track signal present (normal opera2on)

No track signal present.

(Loconet® B, B-Bus, CDE, Track Sniﬀer Input)

Booster load under 90%.

(LED becomes brighter under load)

Booster load greater than 90%.

Short circuit detected

Stop command detected (e.g. by the control unit)

Track Out reversed polarity.

Note:

If the blue LED lights up when driving over the booster separa2on

points, the track output of the DR5033 is connected with reversed polarity.

www.digikeijs.com

® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz

Stand 2019-10-14

P 5