Digikeijs DR5033 사용 설명서 - 페이지 6

{카테고리_이름} Digikeijs DR5033에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digikeijs DR5033 18 페이지. 3-ampere, h-bridge dcc booster
Digikeijs DR5033에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지), 사용 설명서 (18 페이지)

페이지 인쇄
Digikeijs DR5033 사용 설명서
DR5033 DIGIBOOST
3.0 Adjusting the DR5033 Configuration
The DR5033 is a DCC booster whose settings (LocoNet® module address, magnetic article address, etc.) can be easily adjusted via LNCV programming. With the
LNCV 3, the behaviour (short-circuit behaviour, start behaviour, automatic polarity reversal, etc.) of the booster can be adapted.
1.
Connect the DR5033 to the LocoNet B port on the DR5000.
(Important!
if LocoNet® module addresses are identical or if the LocoNet® module address is un-
known, only one DR5033 may be plugged into the LocoNet®.)
2.
Connect the DR5033 to the power supply.
3.
Call the "LNCV Programming" programming menu of the DR5000 under Loconet B.
4.
Select the DR5033 from the list or enter its product number numerically.
5.
Read out or enter the module address via the button. (Delivery State =1)
6.
If necessary, assign a free module address. (Delivery State =1)
7.
If a new address has been assigned, the newly assigned address must of course also be entered in
the "Module address" selection field, otherwise further programming of the DR5033 is not possible.
8.
Enter the CV number to be changed or read in the input field.
9.
Enter the desired value or select the bits to be set.
10.
Use the "Read value" or "Write LNCV value" buttons to read out the LNCV or write it to the booster.
This bar indicates the progress of the read or write process.
11.
Message display of the read/write operation.
TIMEOUT
No module detected (possibly wrong module address entered?!)
OKAY
Read/write operation performed correctly.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
Stand 2021-07-06
1
2
3
5
4
5
7
8
10
6
9
11
P 6